Average Cost to Repair Transmission Linkage? If your transmission linkage is not malfunctioning but is loose, your mechanic can run a diagnostic scan and tighten it up for about $150. If you need to replace your transmission linkage it will set you back at least $250 with parts and labor.
If the cable is broken, you’ll be able to move the shifter into any position, but the transmission will stay in the same gear. This may leave you stuck in gear, or even stuck in park depending on when the cable broke.
The process is very easy and hardly takes around 20 minutes to fix. Here are a few steps you should keep in mind to fix it in the right and safest way. Put the transmission on neutral and block the wheels of the vehicle.
With bushings, thumping, bumping, squealing, and whirring sounds are most common. This indicates a problem with the shift linkage, and that problem could be a worn bushing. Finally, transmission fluid leaks can indicate a problem with the bushing.
If you suspect yours is failing, watch for the following symptoms.
- Indicator doesn’t match the gear. If the shift selector cable is going bad, the indicator light or cable will not match the gear you are in. …
- Vehicle will not turn off. …
- Vehicle starts in another gear. …
- Vehicle will not go into gear.
In most cases, faulty automatic linkages are caused by the daily wear and tear or the lack of regular maintenance. If the automatic transmission linkage starts to become faulty, you might notice that it has become challenging to shift your car or truck into gear.
How much does a shifter cable cost?
The average cost for automatic trans shift cable replacement is between $303 and $349. Labor costs are estimated between $177 and $223 while parts are priced at $125. This range does not include taxes and fees, and does not factor in your specific vehicle or unique location. Related repairs may also be needed.
Shift Linkage refers to the car cables that connect the gearshift or gear selector to the transmission.
The shift cable runs up through the firewall and attaches to this lever. The cable runs from the firewall to the transmission gear shift linkage, where it is attached and held securely in place. As the handle is moved, it either pulls or pushes on the cable.
How long does it take to replace a shifter cable?
The time it takes to replace a shift cable will vary across car make and model. On average, the shifter cable takes 1.5-2 hours to install. If the whole cable does not need to be replaced, other repairs on the same part may take less time to complete.
What causes a loose shifter?
Generally speaking, most of the gear shifters will get loose due to excessive gear shifting from the gear shifter. Changing the gear vigorously will inflict harm to the bushing at the bottom of the shifter lever. This will cause slackness in the gear shifter once the bushing is damaged.
Why won’t my car move when I put it in drive or reverse?
If you have ever noticed that your vehicle moves just fine in drive but won’t reverse, that usually is a sign that the fluid is low. You’ll need to have the transmission leak fixed. It could be the pan gasket or the front pump that is leaking. For a temporary fix, add No Leak® Transmission Stop Leak.